Lastly, fill the bottle with water until it covers the opposite end of the pen shaft, load up your cannabis, and you're ready to go.įor something a little different, but also easy to make, try a gravity bong (gb). Make this hole small enough to be able to cover it with one finger. Opposite the side of where the pen shaft is, you'll need to cut another hole for the carb for proper airflow. If you don't have a socket lying around, you can make a makeshift bowl from aluminum foil. You'll probably need to seal the socket to the pen shaft with tape. A socket is a metal cylinder that attaches to a socket wrench, so you can probably find something like it in a toolbox. You'll need to use a small metal socket that can fit in or over the pen shaft to make the bowl work. If the gap is too big, use tape around the hole to fix it and keep the pen shaft in place. Take the pen shaft or hollow tube and place it in the hole at a downward angle. Try not to split the bottle entirely, but don’t worry if it's a large hole you can fix it later. A slightly larger bottle might be better, as some people use a 2-liter, but whatever you have on hand will work.Ībout a third of the way from the bottom of the bottle, cut a small hole with the box cutter or scissors. If you have any other type of small, hollow tube, that will also work. The only thing you'll need from the plastic pen is the pen shaft. Starting with the plastic pen, you'll need to take it apart. It doesn't require too much material or skill, but it does need a little more patience.įor this homemade water bong, you'll need a water bottle, scissors or a box cutter, an old pen, a metal socket, and tape. If you're looking for something more like a real bong, then this is it. Simply place the cannabis in the foil bowl and place your mouth on the hole you created with the scissor. Be careful not to split the entire bottle or create too large of a gap. Then, insert one scissor blade into the hole and wiggle it to expand the spot. Then, find a spot on the bottle about halfway down and poke a small hole with a needle or toothpick. Press the foil down a bit so that the foil forms a bowl inside the opening. Remove the bottle cap and wrap the foil over the mouth of the bottle.
If the foil is too light in weight, cut a larger area and fold it over to make it sturdier. First, start by cutting out a small square of tinfoil of about 2.5 x 2.5 cm in size. The materials you'll need are: an empty water bottle, tin foil, scissors, and a needle/toothpick. This is great if you don't have too much time, or want something to smoke out of in a pinch. Here's one that's a little easier to make since it's just a huge pipe and not a homemade bong.
0 kommentar(er)
